Installation of Renasas Data Intelligence using IoT Fast Prototyping Kit


#1

I am going through the installation process for the Renesas Data Intelligence and I am stuck at the stage of “power cycle the board.” Please advise how I may get this process completed. The board only shows the green, yellow and red LED blinking in steady sequence. Board# is YIOTFASTPROTOS5D9


#2

I should change that. Just unplug the board and plug it back in.

The LED state you mention indicates the board is not loading the binary. Did you update update.txt?

Also, did you see the next section of the documentation?

Does your board files look like this?